Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
Yaw Rate Sensor Inspection
- Connect the connector.
- Turn ignition switch on, verify the voltage between terminals D and ground terminal E under the following conditions.
- Measure combined sensor voltage under static condition.
Voltage
2.3-2.7 V
- Measure voltage at output terminal D and ground terminal E when the combined sensor is rotated left and right.CAUTION:
- Be careful when turning the combined sensor rotation position while it is in a reversed state because the rotation direction and voltage will be reversed.
Voltage
Right rotation: fluctuation between 2.5-4.62 V
Left rotation: fluctuation between 2.5-0.33 V
- Measure combined sensor voltage under static condition.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
