2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Abs/TCS HU/Cm Removal/Installation: Notes

CAUTION:
  • When replacing the ABS/TCS HU/CM, the configuration procedure must be done before removing the ABS/TCS HU/CM. If the configuration is not completed before removing the ABS/TCS HU/CM, TCS will not work properly after installation of the ABS/TCS HU/CM.
  • Do not drop the ABS/TCS HU/CM. Replace it if it is subjected to an impact.
  1. Configure the ABS/TCS HU/CM (only when replacing it). (See ABS/TCS HU/CM CONFIGURATIONΒ ).
  2. Remove in the order indicated in the table.
  3. Install in the reverse order of removal.
    Fig 1: ABS/TCS HU/CM & Torque Specification
    G04325959Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.