Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE
[G35M-R, A65M-R]
Service Specifications
Clutch:
Torque and Sequence
G35M-R manual transaxle models
Tighten the bolts evenly and gradually in a crisscross pattern.
Tightening torque
25 - 33 N-m (2.6 - 3.3 kgf-m, 19 - 24 ft-lbf)
A65M-R manual transaxle models
Tighten the bolts evenly and gradually in a crisscross pattern.
Tightening torque
25 - 33 N-m (2.6 - 3.3 kgf-m, 19 - 24 ft-lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.