Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Powertrain Management: Technical Service Bulletins
- Recalls
- Customer Interest
- Emissions - MIL ON/DTC's P0441/P0442/P0455/P0456 Set
- Emissions - MIL ON/DTC P0441 Set
- Engine Controls - MIL ON/DTC P0601 Set
- Engine Controls - Engine Stalls Driving at Low Speeds
- Engine - MIL ON/DTC P2006 Set
- AT, Engine Controls - ECM/TCM Update
- Engine Controls - Engine Stalling at Low Speeds
- Body - Windows Open Unintentionally
- Engine - Unstable Idle/Engine Stalling
- Exhaust System - Rubbing Noises At Idle
- Exhaust System - Rubbing Noise At Idle
- Engine - VVT Noise At Engine Start Up
- By Symptom
- Customer Interest
- Emissions - MIL ON/DTC's P0441/P0442/P0455/P0456 Set
- Emissions - MIL ON/DTC P0441 Set
- Engine Controls - MIL ON/DTC P0601 Set
- Engine Controls - Engine Stalls Driving at Low Speeds
- Engine - MIL ON/DTC P2006 Set
- AT, Engine Controls - ECM/TCM Update
- Engine Controls - Engine Stalling at Low Speeds
- Body - Windows Open Unintentionally
- Engine - Unstable Idle/Engine Stalling
- Exhaust System - Rubbing Noises At Idle
- Exhaust System - Rubbing Noise At Idle
- Engine - VVT Noise At Engine Start Up
- Driveability
- Erratic Operation
- Noise
- Odors
- Recalls
- Sticking/Binding
- Customer Interest
- All Technical Service Bulletins
- Exhaust System - Excessive Sulfur Odors
- Fuel System - Fuel Ethanol Content Testing
- Computers/Controls KAM Memory Clearing After VVT R & R
- Fuel System - Ethanol Fuel Usage
- Electrical - Lightning Strike Information
- Engine Controls - O2 Sensor Removal Precautions
- Emissions - MIL ON/DTC's P0441/P0442/P0455/P0456 Set
- Emissions - MIL ON/DTC P0441 Set
- Engine Controls - MIL ON/DTC P0601 Set
- Computers/Controls - Module Reprogramming Precautions
- Engine Controls - Revised DTC P0441 Diagnostics
- Engine Controls - Engine Stalls Driving at Low Speeds
- Recall - ECM Update for OBD Functions
- Engine - MIL ON/DTC P2006 Set
- Ignition System - Spark Plug Removal/Installation
- AT, Engine Controls - ECM/TCM Update
- Engine Controls - Engine Stalling at Low Speeds
- A/T - Range Switch Removal/Installation Caution
- Fuel System - Servicing Precautions
- Body - Windows Open Unintentionally
- Recall 08V412000: Fuel Tank Repair/Replacement
- Recall - Fuel Tank Inspection/Replacement
- Engine - Unstable Idle/Engine Stalling
- Exhaust System - Rubbing Noises At Idle
- A/T - Speed Sensor Replacement
- Exhaust System - Rubbing Noise At Idle
- Engine - VVT Noise At Engine Start Up
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.