Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Ignition Switch: Service and Repair

IGNITION SWITCH REMOVAL/INSTALLATION

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the meter hood.
4. Remove the column cover.

Power System Location Index:

5. Remove in the order indicated in the above table.
6. Install in the reverse order of removal.

Ignition Switch Connector Removal Note

1. Rotate the lever in the direction of the arrow and remove the connector.

Ignition Switch Connector Installation Note

1. After connecting the connector, rotate the lever in the direction of the arrow to install the connector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.