Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Engine Temperature Sensor: Testing and Inspection
ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION[L3]
Resistance Inspection
NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart.
1. Disconnect the ECT sensor connector.
2. Remove the ECT sensor.
3. Place the ECT sensor in the water and while increasing the water temperature, measure the resistance between ECT sensor terminals A and B.
- If the monitor item status/specification (reference) is not within the specification, even though the ECT sensor resistance is within the specification, perform the "Circuit Open/Short Inspection".
- If not within the specification, replace the ECT sensor.
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)
Open circuit
- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
- ECT sensor terminal A and PCM terminal 2AK
- ECT sensor terminal B and PCM terminal 2AA
Short circuit
- If there is continuity, there is a short circuit. Repair or replace the wiring harness.
- ECT sensor terminal A and power supply
- ECT sensor terminal A and body ground
- ECT sensor terminal B and power supply
Resistance Inspection
NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart.
1. Disconnect the ECT sensor connector.
2. Remove the ECT sensor.
Standard:
3. Place the ECT sensor in the water and while increasing the water temperature, measure the resistance between ECT sensor terminals A and B.
- If the monitor item status/specification (reference) is not within the specification, even though the ECT sensor resistance is within the specification, perform the "Circuit Open/Short Inspection".
- If not within the specification, replace the ECT sensor.
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)
Open circuit
- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
- ECT sensor terminal A and PCM terminal 2AK
- ECT sensor terminal B and PCM terminal 2AA
Short circuit
- If there is continuity, there is a short circuit. Repair or replace the wiring harness.
- ECT sensor terminal A and power supply
- ECT sensor terminal A and body ground
- ECT sensor terminal B and power supply
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.