2007 Mazda 5 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Radiator Support: Service and Repair

SHROUD PANEL REMOVAL/INSTALLATION

CAUTION: Because the shroud panel is installed to the front bumper reinforcement, support the shroud panel using a jack before removing the front bumper reinforcement so as not to apply excessive force to the shroud panel.

1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. Front bumper
2. Front combination lights
3. Front bumper reinforcement
4. Hood latch

4. Remove in the order indicated in the table.

Factory service manual diagram





5. Install in the reverse order of removal.

Upper Mount Rubber Bracket

Factory service manual diagram





1. Remove the upper mount rubber bracket while pressing down the upper mount rubber bracket tab in the direction of the arrow.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.