2007 Mazda 3 Mazdaspeed, 2.3 MFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure (Map) Sensor/Boost Air Temperature Sensor Removal/Installation

  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Remove the oil level gauge pipe. (See OIL PAN REMOVAL/INSTALLATION .)
  4. Disconnect the MAP/boost air temperature sensor connector.
  5. Remove MAP/boost air temperature sensor from the intake manifold.
  6. Install in the reverse order of removal.

    Tightening torque 

    5.0-7.0 N.m {51-71 kgf.cm, 45-61 in.lbf} 

    Fig 1: Identifying MAP/Boost Air Temperature Sensor
    G04955332Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.