2007 Mazda 3 Mazdaspeed, 2.3 MFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure (Map) Sensor Inspection: Notes

NOTE:
  • Perform the following inspection only when directed.
  • The following vacuum values are indicated by relative pressure from the MAP sensor.
  1. Connect the M-MDS to the DLC-2.
  2. Turn the ignition switch to ON (Engine off).
  3. Select MAP PID on the M-MDS.
  4. Verify that the MAP PID (pressure) and barometric pressure are practically equal.
    • If not as verified, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
      • If there is no open or short circuit, replace the MAP sensor.
    • If as verified, go to next step.
      Fig 1: Identifying Data Link Connector 2
      G04955308Courtesy of MAZDA MOTORS CORP.
  5. Apply vacuum of-25.0 kPa {-187 mmHg, -7.38 inHg}  to the MAP sensor, and verify that the MAP variation from that of Step  4 is approx. 25.0 kPa {187 mmHg, 7.38 inHg}. 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.