Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 3 Mazdaspeed, 2.3 MFACTORY OEM SERVICE PROCEDURE
Resistance Inspection
NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL .)
- Disconnect the MAF/IAT sensor.
- Measure the resistance between the MAF/IAT sensor terminals D and E using a tester.
- If not as specified, replace the MAF/IAT sensor. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
- If the MAF/IAT sensor is normal, but the PID is out of specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
AMBIENT TEMPERATURE AND RESISTANCE SPECIFICATIONAmbient temperature (°C {°F}) Resistance (kilohm) 20 {68} 2.21-2.69 60 {140} 0.493-0.667
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
