2007 Mazda 3 Mazdaspeed, 2.3 LFACTORY OEM SERVICE PROCEDURE

Pcm Removal/Installation

NOTE:
  • For PCM replacement, set up the M-MDS and perform the PCM configuration. (See PCM CONFIGURATIONΒ ).
  1. Remove the battery cover.
  2. Disconnect the negative battery cable.
  3. Disconnect the PCM connector.
  4. When replacing the PCM on the vehicles, perform the following.
  5. Install in the reverse order of removal.
    Fig 1: Removal/Installation Of PCM With Torque Specification
    G04955294Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.