Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 3 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Rear Wheel Alignment
TOTAL TOE-IN
Tire: 2mm(0.08 in.)
(degree) 0°11'±0°22'
CAMBER ANGLE
Fuel gauge indication
Empty -1°20'±1°
1/4 -1°21'±1°
1/2 -1°23'±1°
3/4 -1°25'±1°
Full -1°27'±1°
Difference between left and right must not exceed 1°30'.
THRUST ANGLE 0°οΏ½0°48'
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.