2007 Mazda 3 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Programming and Relearning

AUTO LIGHT ILLUMINATION LEVEL SETTING

Factory service manual diagram



1. Connect the M-MDS to the DLC-2 (16-pin).
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

When using the IDS (laptop PC)
- Select "Module programming".

When using the PDS (Pocket PC)
- Select "Programming".
- Select "Module programming".

3. Select "Programmable Parameters".
4. Select "Exterior Lighting".
5. Select "Autolamp On Setting - (GEM)".
6. Select "Standard" other or "Low other" on the M- MDS to set the illumination level.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.