Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mazda Tribute s, FWDFACTORY OEM SERVICE PROCEDURE
Removal and Installation
NOTE:
- When the PCM is replaced, the new PCM must be programmed with the old module's configuration information. See POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING - WDS .
- Disconnect the negative battery cable. See BATTERY DISCONNECT .
- Remove the powertrain control module (PCM) cover.
- Loosen the bolt and disconnect the electrical connector.
- Remove the nuts and the cover.
- Remove the PCM.
- To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.