Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mazda Mazdaspeed6 L4-2.3L TurboFACTORY OEM SERVICE PROCEDURE
Fuel Injector Control Module: Testing and Inspection
INJECTOR DRIVER MODULE INSPECTION [L3 WITH TC]
1. Inspect using the wave profile.

- If any incorrect voltage is detected, inspect the related system(s), wiring harnesses and connector(s).

Fuel Injector Signal (+)
Injector driver module terminals
- Fuel injection No.1: 1 F(+) - Body ground(-)
- Fuel injection No.2: 1A(+) - Body ground(-)
- Fuel injection No.3: 1A(+) - Body ground(-)
- Fuel injection No.4: 1 F(+) - Body ground(-)
Oscilloscope setting
- 25 V/DIV (Y), 0.2 minutes/DIV (X), DC range
Vehicle condition
- Idle after warm up (no load, P/S off, A/C off)

Fuel Injector Signal (-)
Injector driver module terminals
- Fuel injection No.1:1 E(+) - Body ground(-)
- Fuel injection No.2:1 B(+) - Body ground(-)
- Fuel injection No.3:1C(+) - Body ground(-)
- Fuel injection No.4: 1 D(+) - Body ground(-)
Oscilloscope setting
- 25 V/DIV (Y), 0.2 minutes/DIV (X), DC range
Vehicle condition
- Idle after warm up (no load, P/S off, A/C off)
1. Inspect using the wave profile.
- If any incorrect voltage is detected, inspect the related system(s), wiring harnesses and connector(s).
Fuel Injector Signal (+)
Injector driver module terminals
- Fuel injection No.1: 1 F(+) - Body ground(-)
- Fuel injection No.2: 1A(+) - Body ground(-)
- Fuel injection No.3: 1A(+) - Body ground(-)
- Fuel injection No.4: 1 F(+) - Body ground(-)
Oscilloscope setting
- 25 V/DIV (Y), 0.2 minutes/DIV (X), DC range
Vehicle condition
- Idle after warm up (no load, P/S off, A/C off)
Fuel Injector Signal (-)
Injector driver module terminals
- Fuel injection No.1:1 E(+) - Body ground(-)
- Fuel injection No.2:1 B(+) - Body ground(-)
- Fuel injection No.3:1C(+) - Body ground(-)
- Fuel injection No.4: 1 D(+) - Body ground(-)
Oscilloscope setting
- 25 V/DIV (Y), 0.2 minutes/DIV (X), DC range
Vehicle condition
- Idle after warm up (no load, P/S off, A/C off)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
