Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mazda MX-5 Miata BaseFACTORY OEM SERVICE PROCEDURE
Load Compensation Inspection
- Start the engine and idle it.
- Connect the WDS or equivalent to the DLC-2.
- Verify that P0506, P0507, or P0511 is not displayed.
- If P0506, P0507 or P0511 are displayed, perform DTC inspection.
(See DTC TABLE .)
- If P0506, P0507 or P0511 are displayed, perform DTC inspection.
- Access the RPM PID.NOTE:
- Excludes temporary idle speed drop just after the loads are turned on.
- Verify that the engine speed is within the specification under each load condition. (See ENGINE TUNE-UP
.)
- If load condition is not as specified, inspect the following:
- A/C switch and related wiring harness
(See CLIMATE CONTROL UNIT INSPECTION .)
- Fan switch and related wiring harness
(See CLIMATE CONTROL UNIT INSPECTION .)
- A/C switch and related wiring harness
- If load condition is not as specified, inspect the following:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.