2006 Mazda MX-5 Miata BaseFACTORY OEM SERVICE PROCEDURE

Security Access Procedure

  1. Connect the WDS or equivalent to the DLC-2.
    Fig 1: Locating DLC-2 Connector
    G04323300Courtesy of MAZDA MOTORS CORP.
  2. Select "BODY/SECURITY/PATS (immobilizer) function" from the WDS or equivalent screen menu.
  3. Select the items to be performed from the following:
    • Additional card key programming
    • Card key ID number clearing
    • Steering lock unit programming
    • Ignition key additional programming (with immobilizer system)
    • Ignition key ID number clearing (with immobilizer system)
    • Customer spare key programming enable (with immobilizer system)
    • Customer spare key programming disable (with immobilizer system)
  4. The security access begins and the WDS or equivalent displays the "OUT-CODE".
    NOTE:
    • When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times  will change the "OUT-CODE".
  5. Input "IN-CODE" corresponding to "OUT-CODE" displayed on the WDS or equivalent screen.
  6. If the security access is successful, selected item can be performed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.