2006 Mazda MX-5 Miata BaseFACTORY OEM SERVICE PROCEDURE

Clearing Card Key [With Advanced Keyless System]

  1. Fully lower the driver-side door glass.
  2. Connect the WDS or equivalent to the DLC-2.
  3. Fig 1: Locating DLC-2 Connector
    G04323300Courtesy of MAZDA MOTORS CORP.
  4. Pull out the WDS or equivalent cable from the door glass opening and set the WDS or equivalent outside the vehicle.
    CAUTION:
    • Protect the cable and body contact area with a clean rag, otherwise they could be damaged.
  5. Select "BODY/SECURITY/PATS (immobilizer)" from the WDS or equivalent screen menu.
  6. Security access begins and the WDS or equivalent displays the "OUT-CODE".
    NOTE:
    • When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times  will change the "OUT-CODE".
  7. Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed in the WDS or equivalent screen.
  8. Select "CARD KEY CLEARING" from the WDS or equivalent screen menu.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.