2006 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Generator Inspection [AJ]: Generator: Current

  1. Verify that the battery is fully charged.
    • Charge if necessary.
  2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION [AJ] .)
    • Replace if necessary.
  3. Disconnect the negative battery cable.
  4. Connect an ammeter, capable of reading 120 A or above, between generator terminal B and the wiring harness.
  5. Connect the negative battery cable.
  6. Turn off all electrical loads.
  7. Start the engine and increase the engine speed to 2,000-2,500 rpm. 
  8. Turn the following electrical loads on and verify that the current reading increases.
    1. Headlights
    2. Blower motor
    3. Rear window defroster
      • If generator terminal B current will not increase, repair or replace the generator as necessary.
      NOTE:
      • Current required for generating power varies with electrical loads applied.

Measuring conditions 

Room temperature: 20 °C {68 °F} 

Voltage: 13.5 V Engine hot 

STANDARD CURRENT (REFERENCE)

Engine speed (rpm) Terminal B current (A)
1,000 0(1)-90
2,000 0(1)-105
(1) Lower limit of current must be more than 0 A.M
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.