2006 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Fan Control Module Inspection

  1. Remove the two bolts from the fan control module with the connectors still connected.
  2. Start and warm up the engine.
  3. Monitor the engine coolant temperature with the WDS  or equivalent.
  4. Measure the voltage at the terminal B of cooling fan control module connector (2 terminals) from the harness side as shown in Fig 1.
    Fig 1: Identifying Fan Control Module Connector
    G04328114Courtesy of MAZDA MOTORS CORP.
    FAN CONTROL MODULE INSPECTION CHART

    Inspection Result
    Condition A/C Engine coolant temp.
    IG SW ON OFF Below 95°C {203°F} Fan stops
    IG SW ON (Idling) OFF Below 95°C {203°F} Fan stops
    IG SW ON (Idling) ON(1) Below 95°C {203°F} 6.9V-12.1V
    IG SW ON (Idling) OFF Above 100°C {212°F} 0.6V-14.6V
    (1) When the magnetic clutch and the middle pressure SW are on.
    • If not as specified, replace the fan control module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.