Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSWINDOW CONTROL SWITCHREMOVAL AND INSTALLATION

2006 Mazda B4000 Base, Automatic

Removal and Installation

2006 Mazda B4000 Base, AutomaticSECTION Removal and Installation

Fig 1: Removing Door Trim Panel Finish Panel Screws

Courtesy of MAZDA MOTORS CORP.

Remove the 2 door trim panel finish panel screws.

Fig 2: Positioning Door Trim Panel Finish Panel
Courtesy of MAZDA MOTORS CORP.
Reposition the door trim panel finish panel.

Fig 3: Removing Window Control Switch From Door Trim Panel Finish Panel
Courtesy of MAZDA MOTORS CORP.
Remove the Window control switch from the door trim panel finish panel.
1. Remove the 2 screws.
  - To install, tighten to 3 N-m (0.3 kgf-m, 27 in-lbf).
2. Remove the window control switch plate from the switch.
3. Remove the window control switch.
To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.