2006 Mazda B3000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Clutch Pedal Position (CPP) Switch Removal / Installation

Fig 1: Removing /Installing Clutch Pedal Position Switch
G04308433Courtesy of MAZDA MOTORS CORP.
  1. Disconnect negative battery cable. See BATTERY DISCONNECT .
  2. Disconnect clutch pedal position (CPP) switch electrical connector.
    Fig 2: Disconnecting Clutch Pedal Position Switch Electrical Connector
    G04308434Courtesy of MAZDA MOTORS CORP.
  3. Spread the CPP switch apart and remove from the pedal rod.
    Fig 3: Connecting Clutch Pedal Position Switch Electrical Connector
    G04308435Courtesy of MAZDA MOTORS CORP.
  4. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.