2006 Mazda B3000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System (Abs) Module Diagnostic Trouble Code (DTC) Index: Notes

NOTE:
  • If DTCs C1095, C1096, C1148, C1158, C1229 and C1950 are set, simply clearing the DTCs after a repair will not turn the yellow ABS/red brake warning light off. Turn the ignition switch to the OFF position. Turn the ignition switch to the ON position, clear the DTCs and drive the vehicle at least 10 km/h (6.25 mph) for the ABS module to confirm normal operation of the system. After this has been completed, the yellow ABS/red brake warning light will turn off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.