2005 Mazda Tribute s, FWDFACTORY OEM SERVICE PROCEDURE

Front Toe Adjustment

  1. Start the engine and center the steering wheel.
    Fig 1: Centering Steering Wheel
    G03725081Courtesy of MAZDA MOTORS CORP.
  2. Turn the engine off, and lock the steering wheel in position.
  3. Check the toe settings. Follow the equipment manufacturer's instructions.
    NOTE:
    • Do not allow the steering gear bellows to twist when the front wheel spindle tie rod is rotated.
  4. Remove the clamps.
    Fig 2: Removing Clamps
    G03725082Courtesy of MAZDA MOTORS CORP.
  5. Loosen the nuts.
    • Clean and lubricate the nut(s) and front wheel spindle tie rod threads.
    Fig 3: Loosening Nuts
    G03725083Courtesy of MAZDA MOTORS CORP.
  6. Rotate the front wheel spindle tie rods.
    Fig 4: Rotating Front Wheel Spindle Tie Rods
    G03725084Courtesy of MAZDA MOTORS CORP.
  7. Tighten the nuts.
    Fig 5: Tightening Nuts & Torque Specifications
    G03725085Courtesy of MAZDA MOTORS CORP.
  8. Install the clamp(s).
    Fig 6: Installing Clamp(s)
    G03725086Courtesy of MAZDA MOTORS CORP.
  9. Recheck the toe settings. Follow the equipment manufacturer's instructions.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.