2005 Mazda Tribute s, FWDFACTORY OEM SERVICE PROCEDURE

Pcm Quick Test

PCM QUICK TEST

STEP INSPECTION ACTION
1 RECORD CONTINUOUS MEMORY DTC AND FREEZE FRAME DATA (FFD)
  • Connect WDS or equivalent tester to the Data Link Connector (DLC).
  • Key ON, Engine OFF (KOEO).
  • Retrieve all stored DTCs.
  • Are any DTCs present? 
 Yes Record all stored DTCs (Continuous Memory DTC) and Freeze Frame Data (FFD) on repair order.
Go to next step.
No Go to next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Check for related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available? 
 Yes Perform repair or diagnosis according to available repair information.
If vehicle is not repaired, go to next step.
No Go to next step.
3 PERFORM KEY ON, ENGINE OFF (KOEO) SELF-TEST
  • Warm engine to normal operating temperature.
  • Key ON, Engine OFF (KOEO).
  • Turn off all electrical loads.
  • Activate KOEO On Demand Self-Test using WDS or equivalent tester Diagnostic Test Modes.
  • Are any KOEO DTCs (except P1000) present? 
 Yes Repair KOEO DTC.
Go to applicable DTC troubleshooting procedure. DIAGNOSTIC TROUBLE CODE NUMBERS  .
No Go to next step.
4 PERFORM KEY ON, ENGINE RUNNING (KOER) SELF-TEST
  • Key ON, Engine Running (KOER).
  • Activate KOER On Demand Self-Test using WDS or equivalent tester Diagnostic Test Modes.
  • Are any KOER DTCs (except P1000) present? 
 Yes Repair KOER DTC.
Go to applicable DTC troubleshooting procedure. DIAGNOSTIC TROUBLE CODE NUMBERS 
No If Continuous Memory DTC was present at step 1, see DIAGNOSTIC TROUBLE CODE NUMBERS  .
If Continuous Memory DTC was not present at step 1, go to SYMPTOM TROUBLESHOOTING .
FUEL PUMP ALWAYS ON  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.