Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2005TRIBUTE I, FWD, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSPOWERTRAIN CONTROL MODULE (PCM) INSPECTIONUSING SST (150 PIN BREAKOUT BOX)
2005 Mazda Tribute i, FWD, Automatic
Using SST (150 Pin Breakout Box)
2005 Mazda Tribute i, FWD, AutomaticSECTION Using SST (150 Pin Breakout Box)
- Disconnect the negative battery cable.
- Disconnect the PCM connector.
- Connect the SST (150 Pin Breakout Box) to the PCM as shown.
- Tighten the connector bolt.
Tightening torque 7.9 - 10.7 N.m (80 - 110 kgf.m, 69.5 - 95.4 ln.lbf)
- Connect the negative battery cable.
- Measure the voltage at each terminal.
- If any incorrect voltage is detected, check related systems, wiring harnesses and connectors referring to the possible malfunction in the terminal voltage list.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.