Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mazda Tribute 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE
Seat Temperature Control Module: Service and Repair
HEATED SEAT MODULE
Removal
NOTE:
- The power seat is shown, the manual seat is similar.
- The driver seat is shown, the passenger seat is similar.
1. Depower the SRS.
2. Remove the front seat.
3. Remove the heated seat module.
- Disconnect the electrical connector.
- Using a small flat-blade screwdriver, release the locking tab and slide the module off the attachment bracket.
Install
1. Install the heated seat module.
- Slide the heated seat module down over the attachment bracket until the locking tab snaps into place.
- Connect the electrical connector.
2. Install the front seat.
3. Repower the SRS.
Removal
NOTE:
- The power seat is shown, the manual seat is similar.
- The driver seat is shown, the passenger seat is similar.
1. Depower the SRS.
2. Remove the front seat.
3. Remove the heated seat module.
- Disconnect the electrical connector.
- Using a small flat-blade screwdriver, release the locking tab and slide the module off the attachment bracket.
Install
1. Install the heated seat module.
- Slide the heated seat module down over the attachment bracket until the locking tab snaps into place.
- Connect the electrical connector.
2. Install the front seat.
3. Repower the SRS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.