Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mazda Tribute 2WD L4-2.3LFACTORY OEM SERVICE PROCEDURE
Body Control Systems: Service and Repair
SMART JUNCTION BOX (SJB)
CAUTION:
Removal and Installation
- Prior to the removal of the SJB, it is necessary to upload module configuration information to a diagnostic tool. Once installed this information needs to be downloaded into the SJB. See MODULE CONFIGURATION.
1. Disconnect the battery.
2. Remove the right side and top of the floor console as needed to access the SJB. See FLOOR CONSOLE - HIGH SERIES.
3. Disconnect the five electrical connectors.
4. Remove the retaining screw.
5. Remove the SJB from the vehicle.
6. To install, reverse the removal procedure.
- Once the SJB is installed, it is necessary to download the module configuration information from the WDS or equivalent Tester into the new module. See MODULE CONFIGURATION.
CAUTION:
Removal and Installation
- Prior to the removal of the SJB, it is necessary to upload module configuration information to a diagnostic tool. Once installed this information needs to be downloaded into the SJB. See MODULE CONFIGURATION.
1. Disconnect the battery.
2. Remove the right side and top of the floor console as needed to access the SJB. See FLOOR CONSOLE - HIGH SERIES.
3. Disconnect the five electrical connectors.
4. Remove the retaining screw.
5. Remove the SJB from the vehicle.
6. To install, reverse the removal procedure.
- Once the SJB is installed, it is necessary to download the module configuration information from the WDS or equivalent Tester into the new module. See MODULE CONFIGURATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.