2005 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE

Control Module HVAC: Testing and Inspection

A/C AMPLIFIER INSPECTION

1. Turn the ignition switch to the ON position
2. Connect the negative (-) lead of the tester to body ground

Terminal Voltage Table (Reference) Part 1:

Factory service manual diagram



Terminal Voltage Table (Reference) Part 2:

Factory service manual diagram



Terminal Voltage Table (Reference) Part 3:

Factory service manual diagram



Factory service manual diagram



3. By inserting the positive (+) lead of the tester into each A/C amplifier terminal, measure the voltage according to the terminal voltage table.
- If there is any malfunction, inspect the parts under "Inspection item(s)".
- If the parts under "Inspection item(s)" are found to be normal, replace the A/C amplifier.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.