Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mazda MPV LXFACTORY OEM SERVICE PROCEDURE
Intake Manifold Communication Control (IMCC) System Inspection
- Connect WDS or equivalent to DLC-2.
- Verify that no DTC detected.
- If any DTC is detected perform appropriate DTC inspection. (See 01-02A-13 ON-BOARD DIAGNOSTIC TEST.)
- Access the IMCC PID.
- Remove the IMCC actuator with connector connected.
- Turn the ignition switch to ON.
- Verify that the IMCC actuator moves when the IMCC PID from OFF to ON using the simulation function.
- If the IMCC actuator does not move, inspect and repair or replace followings:
- IMCC actuator (See INTAKE MANIFOLD COMMUNICATION CONTROL (IMCC) ACTUATOR INSPECTION )
- Harness and connectors between PCM and IMCC actuator.
- If the IMCC actuator does not move, inspect and repair or replace followings:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.