2005 Mazda MPV ESFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS LOCATION

Component Location
C-03 (Gray, 15 Pin) At left side of engine compartment. See Figure .
C-04 (White, 54 Pin) At left kick panel. See Figure .
C-05 (White, 54 Pin) At right side of dash. See Figure .
C-06 (White, 16 Pin) At right front of engine. See Figure .
C-07 (White, 16 Pin) At right front of engine. See Figure .
C-10 (White, 54 Pin) At left kick panel. See Figure .
C-11 (White, 8 Pin) At right side of dash. See Figure .
C-12 (White, 14 Pin) At right side of dash. See Figure .
C-13 (White, 54 Pin) At right kick panel. See Figure .
C-14 (White, 54 Pin) At left kick panel. See Figure .
C-15 (White, 14 Pin) At top left corner of liftgate. See Figure .
C-17 (White, 28 Pin) At left end of dash. See Figure .
C-18 (White, 28 Pin) At right end of dash. See Figure .
C-21 (White, 18 Pin) Below center of dash. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.