2005 Mazda B3000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G1 Behind left headlight. See Figure .
G2 At center rear of engine compartment. See Figure .
G3 At left rear corner of engine compartment. See Figure .
G4 Behind left headlight. See Figure .
G5 At right rear corner of engine compartment. See Figure .
G6 Behind left headlight. See Figure .
G8 Under center of dash. See Figure .
G9 At left kick panel. See Figure .
G10 Under driver's seat. See Figure .
G11 At right kick panel. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.