Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mazda 3 i, AutomaticFACTORY OEM SERVICE PROCEDURE
Resistance Inspection
- Disconnect the CMP sensor connector.
- Measure the resistance between CMP sensor connector terminals A and B.
- If not within the specification, replace the CMP sensor.
- If the monitor item status/specification (reference) is not within the specification, even though the resistance is within the specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ", and repair or replace the malfunctioning part.
Resistance
- 400-550 ohms
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.