Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mazda 3 L4-2.0LFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Pre-Inspection
WHEEL ALIGNMENT PRE-INSPECTION
1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward.
*: Unloaded condition Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
2. Inspect the tire pressure.
^ Adjust to the recommended pressure if necessary.
3. Inspect the wheel bearing play. Correct if necessary.
4. Inspect the wheel runout.
^ Correct if necessary.
5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
6. Rock the vehicle, and verify that the shock absorber operates properly.
7. Measure height H from the center of the wheel to the fender brim.
8. Verify that the difference between the left and right dimension H is within the specification. If it exceeds the specification, repeat the Step 2-7.
Standard 10 mm (0.39 inch) or less
1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward.
*: Unloaded condition Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
2. Inspect the tire pressure.
^ Adjust to the recommended pressure if necessary.
3. Inspect the wheel bearing play. Correct if necessary.
4. Inspect the wheel runout.
^ Correct if necessary.
5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
6. Rock the vehicle, and verify that the shock absorber operates properly.
7. Measure height H from the center of the wheel to the fender brim.
8. Verify that the difference between the left and right dimension H is within the specification. If it exceeds the specification, repeat the Step 2-7.
Standard 10 mm (0.39 inch) or less
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.