Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mazda Tribute LX, 4WDFACTORY OEM SERVICE PROCEDURE
Procedure 2
(For all 2.0L vehicles and 3.0L vehicles with PCMs that have tear tag numbers of SJC0, SJC1, SJC2, HQP1, HQP2, or HQP3.)
NOTE:
- When replacing a powertrain control module (PCM), the following items are required:
- WDS with B18 or later software loaded.
- Minimum two ignition keys for reprogramming PATS (be sure to ask customer for ALL spare keys).
- For 2.0L - obtain new PCM part number YF11-18-881.
- For SJC0, SJC1, and SJC2 - obtain new PCM part number AJ08-18-881F.
- For HQP1, HQP2, and HQP3 - obtain new PCM part number AJ25-18-881.
- With old PCM still in vehicle follow procedure below.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.