Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mazda RX8 2RTR-1.3LFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Technical Service Bulletins
- Recalls
- Customer Interest
- Engine Controls - DTC P2004 Set/MIL ON
- Engine - MIL ON/DTC P2070 Set
- Engine Controls - Lack of Engine Power
- Engine Control - MIL/DTC P0300-P0302 After Engine R & R
- Fuel System - MIL ON/DTC P0456 Set
- Air Bag System - Warning Lamp ON/DTC's B1994/B1998
- Engine Controls - Rough Idle/Hesitation/DTC P0300 Set
- Electrical - MIL ON/DTC P0336 Set
- Engine Controls - Engine Stalls/Multiple DTC's Set
- Engine Controls - No Start/Low Power/DTC's Set
- Instruments - Low Oil Level Lamp ON/Oil Level OK
- Engine Controls - MIL ON/DTC P0128 or P0456 Set
- Engine - Cranks/No Start
- By Symptom
- Customer Interest
- Engine Controls - DTC P2004 Set/MIL ON
- Engine - MIL ON/DTC P2070 Set
- Engine Controls - Lack of Engine Power
- Engine Control - MIL/DTC P0300-P0302 After Engine R & R
- Fuel System - MIL ON/DTC P0456 Set
- Air Bag System - Warning Lamp ON/DTC's B1994/B1998
- Engine Controls - Rough Idle/Hesitation/DTC P0300 Set
- Electrical - MIL ON/DTC P0336 Set
- Engine Controls - Engine Stalls/Multiple DTC's Set
- Engine Controls - No Start/Low Power/DTC's Set
- Instruments - Low Oil Level Lamp ON/Oil Level OK
- Engine Controls - MIL ON/DTC P0128 or P0456 Set
- Engine - Cranks/No Start
- Driveability
- False instrument warning light/gauges
- Loose
- Recalls
- Starting problems
- Customer Interest
- All Technical Service Bulletins
- Electrical - Lightning Strike Information
- Engine Controls - O2 Sensor Removal Precautions
- Engine Controls - DTC P2004 Set/MIL ON
- Computers/Controls - Module Reprogramming Precautions
- Engine - MIL ON/DTC P2070 Set
- Engine Controls - Lack of Engine Power
- Campaign MSP16 - ECM Update for Low Power/Rough Idle
- Engine Control - MIL/DTC P0300-P0302 After Engine R & R
- Fuel System - MIL ON/DTC P0456 Set
- Recall - ECM Update/Spark Plug Replacement
- Air Bag System - SAS Unit Replacement Precautions
- Air Bag System - Warning Lamp ON/DTC's B1994/B1998
- Engine Controls - Rough Idle/Hesitation/DTC P0300 Set
- Electrical - MIL ON/DTC P0336 Set
- Engine Controls - Engine Stalls/Multiple DTC's Set
- Engine Controls - No Start/Low Power/DTC's Set
- Campaign - PCM Reprogram for Hard Start Condition
- Instruments - Low Oil Level Lamp ON/Oil Level OK
- Engine Controls - MIL ON/DTC P0128 or P0456 Set
- Engine - Cranks/No Start
- Recall 05V317000: Exhaust Overheat, Poss. Fire Hazard
- Recall - Excessive Under Car Heat Build Up
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
