2004 Mazda RX-8 1.3 3FACTORY OEM SERVICE PROCEDURE

Resistance Inspection

NOTE:
  • Before performing the following inspection, make sure to follow the troubleshooting flowchart. (See FOREWORD .)
  1. Disconnect the KS connector.
  2. Measure the resistance between KS terminals A and B.

    KS resistance 

    1. 120-280 kilohms 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.