Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Inspection Of Resistance
NOTE:
- Perform the following test only when directed.
- Verify that the ignition switch is at LOCK.
- Disconnect KS connector.
- Measure the resistance between KS terminal A and the KS body using an ohmmeter.
- If not as specified, replace the KS.
- If knock sensor is okay, but PID value is out of specification, perform the "Circuit Open/Short Inspection". See CIRCUIT OPEN/SHORT INSPECTION .
Specification
- Approx. 560 kilohms [20°C {68°F}]
- Reconnect the KS connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.