2004 Mazda B4000 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Idle Air Control (IAC) Valve Removal/Installation - 4.0L

  1. Remove the accelerator control snow shield.
    Fig 1: Removing Accelerator Control Snow Shield - 4.0L
    G01937912Courtesy of MAZDA MOTORS CORP.
  2. Disconnect the electrical connector. Remove the bolts and the idle air control (IAC) valve.
    Fig 2: Removing Idle Air Control (IAC) Valve Bolts - 4.0L
    G01937913Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.