2004 Mazda 6 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Flex Plate

Part 1:

Factory service manual diagram



Part 2:

Factory service manual diagram




Drive Plate sequence

Factory service manual diagram




Tighten the drive plate mounting bolts in two or three steps.
Tightening torque 108 - 116 Nm (11.0 - 11.8 kgf-m, 79.7 - 85.5 ft. lbs.)

Flywheel Runout 0.1 mm (0.004 inch) max.




Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.