2004 Mazda 3 s, 4D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE

Resistance Inspection

  1. Disconnect the CKP sensor connector.
  2. Measure the resistance between CKP sensor connector terminals A and B.
    • If not within the specification, replace the CKP sensor.
    • If the monitor item status/specification (reference) is not within the specification, even though the resistance is within the specification, perform the Circuit Open/Short Inspection , and repair or replace the malfunctioning part.
  1. Resistance 400-550 ohms 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.