2004 Mazda 3 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Crankshaft, Engine

Crankshaft

Crankshaft end play (Standard) 0.22-0.45 mm (0.0087-0.0177 in)
Crankshaft end play (Maximum) 0.55 mm (0.0216 in)
Crankshaft runout (Maximum) H 0.05 mm (0.0019 in)

Main journal bearing size

STD: 51.980-52.000 mm (2.0464-2.0472 in)
USO.25: 51.730-51.750 mm (2.0366-2.0373 in)

Main journal out of round

(Maximum) 0.05 mm (0.0019 in)

Crank pin journal diameter [LF]

STD: 46.980-47.000 mm (1.8497-1.8503 in)
USO.25: 46.730-46.750 mm (1.8398-1.8405 in)

Crank pin journal diameter [L3]

STD: 49.980-50.000 mm (1.9677-1.9685 in)
USO.25: 49.730-49.750 mm (1.9579-1.9586 in)

Crank pin out of round

(Maximum) (0.05 mm (0.0019 in)

Main journal oil clearance

(Standard) 0.019-0.035 mm (0.0007-0.0013 in)
(Maximum) 0.10 mm (0.0039 in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.