Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mazda 3 L4-2.3LFACTORY OEM SERVICE PROCEDURE
Vehicle Lifting: Service and Repair
JACKING POSITIONS
Warning: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking positions and block the wheels.
Use safety stands to support the vehicle after it has been lifted.

Front
At the center of the front crossmember
Rear
At the center of the differential
VEHICLE LIFT (2 SUPPORTS) AND SAFETY STAND (RIGID RACK) POSITION
Vehicle Lift Positions

Front
Both sides of the vehicle, on side sills
Rear
Both sides of the vehicle, on side sills
Safety Stand Positions

Front
Both sides of the vehicle, on side sills
Rear
Both sides of the vehicle, on side sills
Warning: Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack and cause serious injury. Use only the correct front and rear jacking positions and block the wheels.
Use safety stands to support the vehicle after it has been lifted.
Front
At the center of the front crossmember
Rear
At the center of the differential
VEHICLE LIFT (2 SUPPORTS) AND SAFETY STAND (RIGID RACK) POSITION
Vehicle Lift Positions
Front
Both sides of the vehicle, on side sills
Rear
Both sides of the vehicle, on side sills
Safety Stand Positions
Front
Both sides of the vehicle, on side sills
Rear
Both sides of the vehicle, on side sills
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
