2003 Mazda Tribute 2WD L4-2.0LFACTORY OEM SERVICE PROCEDURE

Rear Wheel Alignment

REAR TOE ADJUSTMENT

Note:
^ Jounce the vehicle to make sure that the suspension is in its normal resting position.

1. Check the toe setting using suitable wheel alignment equipment.

Factory service manual diagram




2. Loosen the LH and RH rear suspension trailing arm and bushing bolt.

Factory service manual diagram




3. Turn the LH and RH adjusting cams simultaneously until the toe is within specification.

Factory service manual diagram




4. Tighten the LH and RH rear suspension trailing arm and bushing bolts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.