Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda Protege5 AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| P0500 | VEHICLE SPEED SENSOR (VSS) MALFUNCTION |
| P0705 | TRANSAXLE RANGE (TR) SWITCH CIRCUIT MALFUNCTION (SHORT CIRCUIT) |
| P0706 | TRANSAXLE RANGE (TR) SWITCH CIRCUIT MALFUNCTION (OPEN CIRCUIT) |
| P0710 | TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR CIRCUIT MALFUNCTION (SHORT TO GROUND/OPEN CIRCUIT) (ZM) |
| P0711 | TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR CIRCUIT MALFUNCTION (STUCK) |
| P0712 | TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR CIRCUIT MALFUNCTION (GROUND TO SHORT) (FS) |
| P0713 | TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR CIRCUIT MALFUNCTION (OPEN CIRCUIT) (FS) |
| P0715 | INPUT/TURBINE SPEED SENSOR CIRCUIT MALFUNCTION |
| P0731 | GEAR 1 INCORRECT (INCORRECT GEAR RATIO DETECTED) |
| P0732 | GEAR 2 INCORRECT (INCORRECT GEAR RATIO DETECTED) |
| P0733 | GEAR 3 INCORRECT (INCORRECT GEAR RATIO DETECTED) |
| P0734 | GEAR 4 INCORRECT (INCORRECT GEAR RATIO DETECTED) |
| P0741 | TORQUE CONVERTER CLUTCH (TCC) STUCK OFF |
| P0742 | TORQUE CONVERTER CLUTCH (TCC) STUCK ON |
| P0745 | PRESSURE CONTROL SOLENOID MALFUNCTION |
| P0751 | SHIFT SOLENOID A STUCK OFF |
| P0752 | SHIFT SOLENOID A STUCK ON |
| P0753 | SHIFT SOLENOID A MALFUNCTION (ELECTRICAL) |
| P0756 | SHIFT SOLENOID B STUCK OFF |
| P0757 | SHIFT SOLENOID B STUCK ON |
| P0758 | SHIFT SOLENOID B MALFUNCTION (ELECTRICAL) |
| P0761 | SHIFT SOLENOID C STUCK OFF |
| P0762 | SHIFT SOLENOID C STUCK ON |
| P0763 | SHIFT SOLENOID C MALFUNCTION (ELECTRICAL) |
| P0766 | SHIFT SOLENOID D STUCK OFF |
| P0767 | SHIFT SOLENOID D STUCK ON |
| P0768 | SHIFT SOLENOID D MALFUNCTION (ELECTRICAL) |
| P0771 | SHIFT SOLENOID E STUCK OFF |
| P0772 | SHIFT SOLENOID E STUCK ON |
| P0773 | SHIFT SOLENOID E MALFUNCTION (ELECTRICAL) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.