Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda Protege5 AutomaticFACTORY OEM SERVICE PROCEDURE
OBD-II Drive Mode Description
OBD-II drive mode is performed to inspect proper operation and ensure no additional DTCs are present. During drive mode, following OBD-II systems are inspected:
- EGR system.
- HO2S and HO2S heater.
- Three-way Catalytic (TWC) converter.
- Fuel, misfire and evaporative (EVAP) system.
NOTE:
DO NOT disconnect battery during and after drive mode. Disconnecting battery will reset memory. If OBD-II system inspection is not completed during drive mode, OBD-II system detects malfunction or drive mode procedure has not been completed correctly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
