2003 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Reusing Windshield

  1. Make a hole through the sealant from the inside of the vehicle using an awl.
    WARNING:
    • Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
  2. Pass the SST  (piano wire) through the hole.
  3. Wind each end of the SST  (piano wire) around a bar.
    NOTE:
    • Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.