Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Windshield Removal: Notes
- Remove the rearview mirror. (See REARVIEW MIRROR REMOVALΒ .)
- Remove the base. (See BASE REMOVALΒ .)
- Remove the A-pillar trim. (See
FRONT HEADER TRIM REMOVAL/INSTALLATION
.)NOTE:
- The windshield molding is a replacement part.
- Remove the windshield molding. (See WINDSHIELD MOLDING REMOVAL .)
- Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION .)
- Remove the sunvisor.
- Remove the striker. (See CONVERTIBLE TOP DISASSEMBLY/ASSEMBLY .) (See DETACHABLE HARDTOP DISASSEMBLY/ASSEMBLY .)
- Remove the front header trim. (See FRONT HEADER TRIM REMOVAL/INSTALLATION .)
- Apply protective tape along the edge of the body to protect it from damage.
- Apply protective tape to the dashboard to protect it from damage.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
