2003 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Not Reusing Windshield

NOTE:
  • For the areas of the sealant that are difficult to cut, use the SST (piano wire) and follow the procedures under "Reusing Windshield".
  1. Use a tool like that shown in the figure, and insert the blade into the sealant.
  2. Pull through the sealant around the edge of the glass.
    Fig 1: Breaking Through Sealant Around The Glass
    G01908051Courtesy of MAZDA MOTORS CORP.
  3. Remove the windshield.
  4. Remove the protector.
  5. Remove the spacers.
    Fig 2: Removing Protector
    G01908052Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.