2003 Mazda MX-5 Miata Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Switch Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the power window switch using a flathead screwdriver wrapped with protective tape as shown in the figure.
    Fig 1: Removing Power Window Switch
    G01908038Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.